Fun & Games With Drains

While we have been getting the first fix plumbing and electrics done the builders have been getting the drain ditches dug and the pipes connected. It's been a hard job as a lot of the ground is rock at the left side of the house so the drains have to be quite shallow there and run deeper to the right of the house to allow the fall.

Building regs have checked it all and it just requires some crushed stone as back fill to protect the pipes as they are n a driveway.

When the builders went to connect up with the existing combined sewage and rainwater pipe they found it to be a 3 inch pipe and not the usual 4 inch. This goes through our small garden and into the neighbours stretching down to the road. We asked Yorkshire Water to check the pipe and they sent a contractor (DrainsAid) out to have a look. They told me there was a blockage just before the boundary with the neighbour and it was our responsibility to sort it out.

Consequently we had to call in our own drains company for them to tell me there was no blockage but there were tree roots 25-28 meters away. This was way off our property so Yorkshire water have again attanded to take a loook, I'm now expecting a visit in a week to look at getting rid of the tree roots...anything past our boundary is their responsibility.

We also contacted Yorkshire Water about re-newing the lead pipe that feeds the house but this would mean either digging up my neighbours garden as it follows the same line as the drains or getting a new connection down the access road to the property. Neither option is viable financially or practically so we have asked Yorkshire Water to test the water to make sure it is ok. We are expecting them today...at some point.

First Fix Plumbing and Electrics & Some Plastering

The first fix electrics have been done for a few weeks now, with the plumbing just about done so we took the opportunity to get some plasterboard up in the sections we could.

Took to ebay and got myself an auto screwdriver and a plasterboard lifter and set to work. On all the downstairs ceilings and any stud wall I have put in 100mm of earthwool type insulation to help deaden sound between rooms. I have also put soundblock plasterboard on the downstairs ceilings to stop noise/footsteps from upstairs.

The soundblock boards are much heavier than standard boards, about another 50% at 33kgs, but they are much denser and stronger than standard so hopefully they do actually block sound. We have also used the Soundblock board offcuts on areas that may get a lot of traffic and could be whacked and damaged as it is much stronger.

The plasterboard lifter has been worth its weight in gold. It meant we could lift the heavy boards onto flat ceilings but also onto the pitched ceilings upstairs too.

We have already had the kitchen skimmed by a local plasterer from Honley...The Plasterer Guru! Really good finish, took three days to do the kitchen and very impressed.

All we had to do then were cut holes for the downlights and speakers. Make sure you keep accurate measurements, or you might not get the holes right. We know from experience now!

Pics Below

The kitchen after being boarded and skimmed.

I cut the light holes with a downlight cutter and the speaker holes with a rotozip

Speaker and downlight holes

The boiler mounted on the wall under the stairs.

The living room with sound block plasterboard on the ceiling.

Living room again. We cut the hole in the floor here to get the big window upstairs.

The landing with celotex insulation and plasterboard up.

The en-suite waiting for concrete boards around the shower area. We cut the floor out for a shower tray so it can be tiled on top of.

Master Bedroom.

Office from the landing.

Big Window Goes In

It's been a while since I updated this but I took a few more pics this weekend.  couple of months ago we managed to get the large window in the gable end fitted. It meant cutting a hole in the floor and lifting it through from the ground to the first floor.

Wasn't sure how that would go but with six people (I called in a few mates) it was easy. Once we knew we could get the glass up from the inside we could fit the frame and then lift the glass into place.

Me and my Dad...as with all the windows...fixed in the frame and called a local friendly neighbour just to help lift the glass into the frame.

Looks pretty good, and the house is totally sealed with the exception of draft seals and stormguard on the front and back doors.

The gable end with large window eventually installed

The window up close. Still needs sealing and finishing round the edges.

The window and view from the inside of the bedroom.